6701 Garden Rd. Unit 3
Riviera Beach, FL 33404 USA
Toll Free: 1 (866) 858-4982
Local: (561) 741-7022
Infrared Heaters
These infrared heaters can start up or shut off in seconds and reach peak efficiency in less than a minute. Since they don't lose heat to the air, it uses less fuel and BTU's to go way beyond the comfort level of any standard portable heater.
Great for:
- Drying surfaces, paint and adhesives
- Winter construction sites
- Warms up machines and personnel quickly
- Heating for large warehouses, factories and plants
- Asphalt and concrete preparation
- Personal heating
Straight Heating / Drying
The advantage of spot heating is that only needed areas
are heated.
(I.e. in large warehouses, open sheds and even outdoors etc.)
Radiant heat travels in straight lines and does not rise to the ceiling like hot air.
infrared heaters on the market.
Fuel: Diesel, Kerosene.
Infrared Heaters
Infrared Portable Heater
Features:
- Heat Output BTU/H: 154,237
- Power Supply: 120V, 1 PH, 60 HZ
- Fan Motor Power: 1/4 HP (3,300 RPM)
- Current Rating AMPS 4.1
- Tank Capacity US GAL 17.2
- Run Time 2nd Stage - 1st Stage HOUR 16
- Consumption 2nd Stage - 1st Stage US GAL\H 1.11
- Direct heat flow by radiation with no air movement
- Low noise level
- Built-in oil burner with Danfoss gear pump
- Electronic flame control unit with metal casing
- No supervision required: can be controlled by thermostat, humidistat or timer
- 1ft power cord
- AISI 430 stainless steel combustion chamber
- Metallic forced air insulation pocket between the combustion chamber and the external protection cone
- Automatic post-ventilation cycle to cool down the combustion chamber
- Fuel lines in hydrocarbon-resistant rubber wire-mesh protected
- Shockproof polythene fuel tank
- Screw-on fuel cap
- Fuel tank drain plug
- Possibility of directing the cone up and down with locking mechanism
- Single point lift bail
- Oil filter included (optional pre-heated oil filter)
- Combustion air pressure switch (safety device turns off unit and requires manual reset)
- 12” reinforced plastic wheels
- Floor protection sliding shield
- Single Fuel Line Kit: This accessory allows the unit to recirculate hot oil from the return line back into the filter. The hot oil in the filter eases restarts and increases the performance of the unit in extreme cold temperature
- Weight: 161 lbs
- Dimensions: 59”L x 29”W x 42”H
| MODEL | DESCRIPTION | BTU/h | PRICE |
| 48.7001 | Fire 155 Infrared Portable Heater | 154,237 | $2,874.70 |
Val6 Infrared Heater
Offers high efficiency and low fuel consumption in a portable heater.
Features:
- Heat Output: 111,000 BTU/h 32.5kw
- Nozzle: 0.85 gal/h
- Fuel: Diesel, Kerosene
- Tank Capacity: 9 gallons
- Power Source: 120V 60Hz
- Power Consumption: 80W
- Monitoring System: Photocell flame monitor, 3A fuse
- Adjustable Disc Angle: Tilts upward 20 degrees
- External Dimensions (HxWxL): 36.1" x 25.8" x 27.7"
- Dry Weight: 83.8 lbs
- Stackable in Storage
| MODEL | DESCRIPTION | BTU/h | PRICE |
| KBE5S | Diesel or Kerosene Infrared Heater | 111,000 |  for Pricing |
Warranty Service (29 KB)
Val6 EPX Infrared Heater
The EPX has an output control that enables its user to choose between a high or low output thus making it very economical. This infrared heater is great for heating in a large warehouse, warming up machines and personnel, heats up materials, machines, and working sites. With a 15 gallon tank, the EPX is able to operate for 20 hrs on the low output setting and 15 hrs on the high output setting. This makes it operate all night long without having to refuel.
Features:
- Heat Output: 140,000 BTU/hr
- Fuel: Diesel, Kerosene
- Tank Capacity: 15.4 gallons
- Power Source: 120V 60Hz
- Power Consumption: 123W
- Monitoring System: Photocell flame monitor, 3A fuse
- Tip-over switch and Overvoltage detector
- External Dimensions (HxWxL): 38.2x25.4x48.6 in
- Dry Weight: 110 lbs
| MODEL | DESCRIPTION | BTU/h | PRICE |
| EPX | Diesel or Kerosene Infrared Heater | 140,000 | for Pricing |
EPX Drawing (533 KB)
Val6 Infrared Heater
Equipped with a larger tank enabling it to operate continuously for about 15 hours..
Features:
- Heat Output: 111,000 BTU/h 32.5kw
- Nozzle: 0.85 gal/h
- Fuel: Diesel, Kerosene
- Tank Capacity: 15.1 gallons
- Power Source: 120V 60Hz
- Power Consumption: 80W
- Monitoring System: Photocell flame monitor, 3A fuse
- Adjustable Disc Angle: Tilts upward 20 degrees
- External Dimensions (HxWxL): 40.2" x 28.0" x 27.4"
- Dry Weight: 115 lbs
- Stackable in Storage
| MODEL | DESCRIPTION | BTU/h | PRICE |
| KBE5L | Diesel or Kerosene Infrared Heater | 111,000 | for Pricing |
Warranty Service (29 KB)
Great Advantages
Sunlight Warmth Radiant heat penetrates evenly on and into surfaces just like sunlight.
Best Choice for OutdoorsThe performance is unique in the outdoors, unlike forced air heaters which lose heat from with and cold air.
No Air Movement, Dust Free Generates straightforward infrared heat which is unaffected by air flow, thus creating a comfortable and dust-free environment.
Odorless Perfect combustion system produces no odor and no smoke while running. The exhaust gas goes upward.
Very Low Noise Compared to other space heaters, which can be extremely loud, these heaters have an extremely low amount of noise.
Q&A
What type of fuel can be used?
Diesel #1 or #2, Kerosene.
What is radiant heat?
Radiant heat transfer occurs when infrared light leaves the surface of an object and travels to the surface of other cooler objects .
How many hours of operation time on the heaters?
VL-KBE5S - 10 Hours
VL-KBE5L - 16 Hours
VL-KBE1JA - 15 Hours
VL-DAYSTAR - 6 Hours
VL-HG125NA - 14 Hours
Application Examples of Infrared heaters
and personnel
warehouses
Infrared and Forced Air Heater
Val6 VL-DAYSTAR
Adopts a dual heating system of radiant heat and convection heat.
Features:
- Heat Output: 51,800 BTU/h
- Fuel: Diesel, Kerosene
- Tank Capacity: 2.6 gallons
- Power Source: 120V 60Hz Single phase
- Power Consumption: 105W
- Control System: 5sec. Prepurge, 330sec. Postpurge
- Monitoring System: Photocell flame monitor, 3A fuse. Overheat prevention system, tip over switch
- Burner Type: High pressure spray gun type
- External Dimensions (HxWxL): 23.4" x 12.2" x 22.8"
- Dry Weight: 40 lbs
| MODEL | DESCRIPTION | BTU/h | PRICE |
| DAYSTAR | Diesel or Kerosene Infrared and Forced Air Heater | 51,800 | for Pricing |
Warranty Service (29 KB)
See Also
During winter season we require to use equipment and other tools to clean, remove or maintain your home or work environment. Keep it safe with snow throwers & safety accessories; keep your winter products well maintained with the right tools; keep yourself warm with space heaters; keep temperatures in control with use of air cooled water chiller or with insulated vinyl curtain.
Advantages of Using Infra Red Heaters
All you need to know about inrared heaters and their uses. Achieve maximum heat efficiency.