Kranzle Pumps

COMET Pumps CAT Pumps GENERAL Pumps
AR Pumps	GIANT Pumps	KRANZLE Pumps	Legacy Pumps

Worry-free operation is achieved through advanced design. Most pressure washer pumps with all ceramic plungers are quickly damaged when run without water or left to idle for too long. The Kränzle high pressure pumps can run without water or idle in bypass for hours without damage, preventing expensive accidents caused by operator error. Kranzle self priming pump only work with 2:1 gear-reduced Honda engine; the GX-LX model in gasoline engine configuration. The electric Kranzle pumps have to have a special mounting flange that doubles as transmission housing.  Pumps can start dry and run dry, capable of running in extended bypass. Warranty on pump manifold is 10 years and other components have 1 year warranty. All Kranzle Pumps are capable of self priming from a tank, pond, or ocean. (YES, you can run SALT WATER through these self priming pumps!)*

Pumps can start dry and run dry! Self prime capability!

APG 15 Kränzle Pump

• 3400 Max PSI
• 2.5 GPM Max Flow
• 160°F Maximum Inlet Temperature
• 1800 Max RPM
• 15MM Plunger
• Direct Drive special mount used with 2:1 gear-reduced Honda engine
• Internal Unloader
• Includes pressure gauge
• Freeze Proof!

Ordering Information - FREE Shipping

SKU #	WOBBLE	PSI	GPM	MOTOR REQUIREMENTS	PRICE
DK-0600144	13.0 degree	3000	2.5	5.5 HP Gasoline	$744.50

APG 18 Kränzle Pump

• 2600 Max PSI
• 3.6 GPM Max Flow
• 160°F Maximum Inlet Temperature
• 1800 Max RPM
• 18MM Plunger
• Direct Drive special mount used with 2:1 gear-reduced Honda engine
• Internal Unloader
• Includes pressure gauge
• Freeze Proof!

Ordering Information - FREE Shipping

SKU #	WOBBLE	PSI	GPM	MOTOR REQUIREMENTS	PRICE
DK-0600227	8.0 degree	1450	2.0	2 HP Electric	$708.65
DK-0600160	11.0 degree	1750	3.2	3 HP Electric	$708.65
DK-0600154	11.5 degree	2000	3.5	5.5 HP Gasoline	$742.50

AQ Kränzle Pump

• 3750 Max PSI
• 5 GPM Max Flow
• 140°F Maximum Inlet Temperature
• 1800 Max RPM
• 20MM Plunger
• Direct Drive special mount used with 2:1 gear-reduced Honda engine
• Internal Unloader
• Includes pressure gauge
• Freeze Resistant!

Ordering Information - FREE Shipping

SKU #	WOBBLE	PSI	GPM	MOTOR REQUIREMENTS	PRICE
DK-0600156	8.0 degree	2950	3.9	7.5 HP Electric	$783.50
DK-0600158	10.4 degree	2400	5.0	7.5 HP Electric	$783.50
DK-0600152	8.0 degree	3500	4.2	11-13 HP Gasoline	$816.75
DK-0600159	10.2 degree	2900	5.0	11-13 HP Gasoline	$816.75

AZ 14 Kränzle Pump

• 2175 Max PSI
• 2.2 GPM Max Flow
• 140°F Maximum Inlet Temperature
• 1800 Max RPM
• 14MM Plunger
• Direct Drive special mount used with 2:1 gear-reduced Honda engine
• Internal Unloader
• Includes pressure gauge

Ordering Information - FREE Shipping

SKU #	WOBBLE	PSI	GPM	MOTOR REQUIREMENTS	PRICE
DK-0600151	9.5 degree	1150	2.2	1.5 HP Electric	$631.85

* Over time, salt water will damage brass pump heads like those used on Kränzle high pressure pumps. Seawater attacks the zinc in the brass, creating small holes around the valve seats. Critical factors to consider are the percentage of salt content and the water temperature. When salt concentration is less than 5% and water temperature is less than 75° F, the pump head should last from 2-5 years. So, using salt water through your Kränzle self priming pump voids the ten-year pump head warranty. Nonetheless, Chesapeake Bay crabbers have used Kränzle pressure washers successfully for over five years at a time with no reported problems. Tip - when pumping salt water through your pressure washer, make sure you flush the pump out with fresh water after you are done. At the very least, pump the pump head dry if no fresh water is available.

For more information about seal and valve kits,
contact us at Toll Free 866-858-4982

Please call to place an order.