Fire 155 Infrared Portable Heater

Features

• Heat Output BTU/H: 154,237
• Power Supply: 120V, 1 PH, 60 HZ
• Fan Motor Power: 1/4 HP (3,300 RPM)
• Current Rating AMPS 4.1
• Tank Capacity US GAL 17.2
• Run Time 2nd Stage - 1st Stage HOUR 16
• Consumption 2nd Stage - 1st Stage US GAL\H 1.11
• Direct heat flow by radiation with no air movement
• Low noise level
• Built-in oil burner with Danfoss gear pump
• Electronic flame control unit with metal casing
• No supervision required: can be controlled by thermostat, humidistat or timer
• 1ft power cord
• AISI 430 stainless steel combustion chamber
• Metallic forced air insulation pocket between the combustion chamber and the external protection cone
• Automatic post-ventilation cycle to cool down the combustion chamber
• Fuel lines in hydrocarbon-resistant rubber wire-mesh protected
• Shockproof polythene fuel tank
• Screw-on fuel cap
• Fuel tank drain plug
• Possibility of directing the cone up and down with locking mechanism
• Single point lift bail
• Oil filter included (optional pre-heated oil filter)
• Combustion air pressure switch (safety device turns off unit and requires manual reset)
• 12" reinforced plastic wheels
• Floor protection sliding shield
• Single Fuel Line Kit: This accessory allows the unit to recirculate hot oil from the return line back into the filter. The hot oil in the filter eases restarts and increases the performance of the unit in extreme cold temperature
• Weight: 161 lbs
• Dimensions: 59"L x 29"W x 42"H